 |
|
| |
| T H E S P A C
E |
| The minimum active space required
is 7.5 meters by 7.5 meters by 3.5 meters high,
or 25 feet by 25 feet by 12 feet high. The major
consideration in terms of space is the total avoidance
of ambient light. The space should be painted
white but no light source should exist, other
than the one that emanates from the projectors
themselves. The entrance must be well insulated
from light and sound. Most ideal is a double trap
door with sound insulating material. (See floor
plan and entrance diagrams.) |
|
| |
| E Q U I P M E
N T |
| The Vasulkas can provide
all the equipment listed below, or share resources
with the exhibitor. This will be reflected in
both shipping and equipment budgets. |
| |
4 matching
projectors
4 projector stands
4 Pioneer Video Laser Disk Players, LD-V series
4 program video laser disks, NTSC, color
1 four channel synchronizer
2 stereo audio amplifiers (4 audio channels) |
| NOTE: The laser disk
synchronizer used by the Vasulkas is custom built
and interfaces only with Pioneer Industrial Laser
Disk Players (2200 to 8000 Series). It is not
interchangeable with laser disk players from other
manufacturers, such as Sony and Phillips, which
require a commercially available synchronizing
device. |
|
|
|
| P R O J E C T O R S S
P E A K E R S P L A C E M E N T |
| The projectors are placed on the
floor in the middle of the exhibition space aiming
into the four corners, breaking the video frame
on the two walls. The speakers are dispersed at
equal distances in the hall. |
|
|
|
| S O U N D A N
D I M A G E A D J U S
T M E N T |
| Treble should be normal and bass
at maximum. Contrast should be high and brightness
below middle. The basic rule here is to set up
the proper deep color black as a reference to
the maximum contrast and brightness. With that,
the other components (hue, color saturation) can
be assigned. The persons installing the environment
must use their esthetic judgment as to the proper
monitor settings for maximum visual impact. |
|
|
|
| D A I L Y O P
E R A T I O N S |
TO START:
Power up disk players and synchronizer, turn the
projectors on (verify pilot light). Wait a short
while to verify that the installation is starting
synchronously. If not, turn power off and on again
for the players and synchronizer, NOT THE PROJECTOR.
If problem persists, notify Steina by phone, fax,
or e-mail. TO SHUT DOWN:
Turn the projector’s power off locally
(the fan will keep going until the units have
sufficiently cooled down). After the fans stop,
turn off power distributors for the projectors,
disk players, and synchronizer. Attention: the
projectors may only be turned off by the power
switch on the units and never by pulling the
cable out, as the unit needs to be cooled down
(about one minute) by the internal fan.
MAINTENANCE:
The projection lenses and the mirrors need to
be cleaned with a soft cloth at least once a
week. |
|
|
|
| P O W E R R
E Q U I R E M E N T S |
| |
(depending
on equipment used)
Video projectors:
Stereo amplifiers:
Video disk players:
Synchronizer: |
Sharp XG-2000U
Sharp XV- P10U
Pioneer 2200
Pioneer 8000
Jericho Data Systems |
230 watts
175 watts
150 watts
70 watts
100 watts
40 watts |
|
| Outside USA, use a Power
Transformer 220 to 110, 1000w. |
|
|
|
| S H I P P I N G
I N F O R M A T I O N |
| Installation is shipped in three
crates. Weight and dimensions available upon request. |
|
|
|
|
|
|
| |
|
|
